The rise of small batch custom hand plate model

Speaking of hand plate, many people in the industry will generally think of one or a few samples of the appearance and structure of the test product, the general number is small, and the verification is not very useful. In fact, it was just a few years ago, now a part of the hand plate has become a personalized customized products.

There are hand plates that need to send samples for testing, and there are also hand plates that substitute products for customers. Now many professional industry products will not end up in mass production. If we open a set of molds that cost tens of millions of products, it is too high a cost. So many of these manufacturers, will look for a reliable hand plate manufacturers, hand plate custom way to do products, although the product unit price is relatively high, but do not need the mold fee, the final calculation if the amount is not large, do small batch cost-effective is z high. He has several benefits

Short cycle: a set of product mold, even if the cycle of overtime work is more than 30 working days, plus the early mold design repair mold and so on to more than 45 working days, but small batch hand plate customization is not needed, do a silicone mold or low pressure perfusion mold short two or three days, complex is only a week, you can start out

Low price: If the final production quantity of the product is not large, the high mold cost can not be shared, so counted up, the cost of one hundred thousand products is too high, but the price will be much lower through small batch customization

Flexible product upgrade: Once the mold is ready, if you want to upgrade the appearance of your product or change the structure of your product, you need to modify the mold or even open a new set of mold, which increases a lot of time and cost. But hand plate small batch customization does not have this problem, hand plate small batch customization mold is cheap, and the cycle is short, if the product is to be modified. Can help you complete the product upgrade in as little as a week at a very low cost.

Of course, so everything has his double-sided, hand plate small batch in convenience, there will be his shortcomings, because his mold material is silica gel, not as stable as steel, so his pieces will be larger than the mold tolerance, consistency is not as good as the mold. Another point is that small batch custom materials have limitations, if you want special materials, it is also difficult to meet. So when looking for small batch manufacturers, we must find manufacturers with sufficient experience and strength.

Now, there are a lot of products, are taking the route of small batch customization, such as the supply of some special site equipment, as well as medical equipment and automobile trial production and robots are widely used